Publicidad
Idiomas disponibles
Idiomas disponibles
By pressing the MEAS key, after having displayed the welding
current and voltage readings, the display shows the following
pages.
Reading of the actual voltage and corresponding graphics rela-
ting to the welding time.
Reading of the actual current and corresponding welding time.
If the screen is in graphic display mode and the MEAS key is
pressed, the welding current and voltage will appear directly in
graphic form.
If the MEAS key is pressed again, the voltage and current para-
meters will be displayed full-screen.
By pressing any key, you can quit the readings page and return
to the display of the parameters set.
Whenever the operator is not in the welding phase, the last data
acquired remain unaltered.
24
9.0 LANGUAGE SETTING
Press for 2 sec. the DATA CHANGE key from one of the menù to
select the welding process, to display the language, light and
contrast choice, and remote control chosen, a tig pulsed and
medium frequency base current (simply amps or welding current
percent).
With the T6 keys, select the new language, the "ON-OFF-
AUTO" parameter for display light and display contrast, the
remote control, the base current selection and regulation mode.
Confirm with ENTER key.
T6 Key
The HSM (Hot Start MIG) enable (ON) allows you to increase the
current in the starting phase during welding of steel to facilitate
striking and stabilisation.
The WU TIG and WU MIG parameters allow you to set the
cooling unit operating mode in MIG and TIG.
WU TIG OFF = unit always off
WU TIG 5min= 5min post-welding activity
WU MIG ON = unit always on
WU MIG 5min= 5min post-welding activity
Publicidad
