Selco RC10 Instrucciones De Uso página 30

13.0 SETTING THE PARAMETERS FOR
MIG/MAG WELDING
Select the process by pressing the ENTER key.
Select the type of material of the wire with which you wish to
carry out the welding, by pressing the T6 keys. Press ENTER to
confirm the selection.
1 Fe = Mild steel
2 Ss = Stainless stell
3 AlMg = Aluminium Magnesium
4 AlSi = Aluminium Silicon
5 Al = Aluminium
6 RFCWFe = Rutil flux cored wire mild steel
7 MCWFe = Metal flux cored wire mild steel
8 BFCWFe = Basic flux cored wire mild steel
9 FCWSs = Flux cored wire stainless steel
10 CuAl = Copper Aluminium
11 CuSi = Copper Silicon
Press the T6 keys to select the type of gas with which ou wish to
carry out the welding. Press ENTER to confirm the selection.
30
Choose the diameter of the wire, using the T6 keys. Confirm the
selection through the ENTER key.
Enter the progression speed of the wire . The generator gives the
recommended voltage value. Change, whenever necessary, the
speed of the wire and the welding voltage by using respectively
keys T7 and T6.
Use the function key F2 to select 2-stroke, 4-stroke or timer wel-
ding, crater filler.
In the case of timed welding, the pre-set welding time, which
can be modified as required, appears at the end of the list of
parameters.
In crater filler mode the following will appear:
- Initial increment (%)
- Crater filler (%)
Use the function key F4 to activate or deactivate the remote con-
trol to set the speed of wire progression and the welding voltage.