Fein KBH25S Instrucciones De Uso página 16

OBJ_BUCH-0000000153-004.book Page 16 Monday, September 3, 2018 11:40 AM
en
16
Mounting the drill chuck (KBH25-2U (**)) (figure 5).
Pull the clamping sleeve of the tool holder back and insert the drill chuck.
Turn the drill chuck until the sleeve snaps back to the starting position.
Fig. 5
Mounting application tools
(KBH25-2U (**)) (figure 6).
To loosen the lock of the drill chuck, turn the
rear sleeve toward the " " direction.
Unscrew the front sleeve to replace the appli-
cation tool.
Tighten the front sleeve and lock the drill
chuck by turning the rear sleeve toward the
" " direction.
1.
Tool holder
2.
Drill chuck
3.
4.
Fig. 6
Drill Bit
5.
4.
1.
2.
3.
Drill chuck