Fein KBH25S Instrucciones De Uso página 22

OBJ_BUCH-0000000153-004.book Page 22 Monday, September 3, 2018 11:40 AM
en
22
RESET (figure 14).
Fig. 14
On/Off switch
If the motor turns after switching the machine
on, but the clamped core bit does not rotate,
a reset must be carried out.
Insert the core bit into a fitting drill hole and
1.
switch the machine on. Press the collar of the
core bit against the workpiece.
n = 0
When the core bit rotates, pull the core bit
2.
out of the drill hole and switch the machine
off.
RESET
3.
4.
5.
8.
9.
6.
7.
6.
n = 0
n 0