Publicidad
Idiomas disponibles
Idiomas disponibles
Step 2: Unfastening the operation panel
and detaching the filter
Open the packaging and take out the
1.
indoor unit. Remove the protective
tape and any components.
Open the two boxes for storing the
2.
remote control found on either side
of the indoor unit, then undo the
screws on the operation panel.
3.
Use both hands to gently hold the
decorative part at the top of the
operation panel, then lift it upwards
to remove it along with the wire
terminal which is connected to it.
Undo the two screws on the front of
4.
the filter.
Use both hands to hold the two
5.
sunken areas on either side of the
filter and pull away from the unit. Lift
the filter upwards to remove it.
Please take off the air-inlet grid
6.
before connecting
First remove the screws cover, then
remove the screws on the air-inlet
grid, then take off the grid.
Remove all of the accessories placed
7.
inside the bottom cavity of the indoor
unit.
Check that all of the accessories
8.
match those found on the "Instal-
lation Diagrams and Accessories" as
shown on the previous page.
the pipes/wires.
Air-inlet Grid
V.3
Step 3. Remove the fasteners from the
roller (only found on selected models)
Check to see whether the roller on
1.
the indoor unit has any fasteners
holding it in place and tear off the
notice sticker.
Remove the fasteners from the
2.
roller according to the directions on
the sticker.
Step 4. Fastening the indoor unit (to
prevent it from falling down)
1. Measure the position of the holes for
installation.
2. Insert the M8 bolts into the unit
while it is on the floor (the amount
of bolts used depends on the num-
ber of holes on the unit's chassis).
3. Lift up the indoor unit so that the
installation holes cover the bolts,
then fasten the nuts onto the bolts
and tighten them.
screw bolt fixing hole
CAUTION
If further support is needed to prevent
the unit from falling down, a protective
wedge can be installed. The installation
procedure for this wedge is as follows:
Take out the protective wedge
•
and measure the correct size.
Use the self-tapping screws to
•
fasten the protective wedge to
the top cover of the indoor unit.
Fasten the other end of the wed-
•
ge tightly to the wall using the
self-tapping screws.
Step 5. Installing the rodent-proof mesh
1. Remove the metal rodent-proof mesh
from the piping found on the unit by
gently tapping on it.
21
Publicidad
