Publicidad
Idiomas disponibles
Idiomas disponibles
OPTIONAL FUNCTION
No.
Item
Optional function
81
Eco-operation
J8
82
Not used
J9
83
Not Used
jA
84
Not Used
jb
85
Not used
1
86
Not used
2
87
Not used
3
88
Not used
4
Detection level of the motion
89
5
sensor kit
Selection of allowed
operation modes when the
90
6
control sensor of the indoor
unit is set by C8 function
91
Not used
7
Control for the prevention of
92
8
condensation on the louvres.
18
PMML0497 rev.1 - 12/2020
Individual
Settings
Setting
Function disabled
00
(factory setting)
×
01
Function enabled
00
-
-
01
-
00/01
-
-
00/01
-
00
-
-
01
00
-
-
01
00
-
-
01
00
01
-
-
02
03
00
Standard (factory setting)
○
01
High
02
Low
00
All modes allowed
01
Only cooling/dry allowed
○
02
Only heating allowed
03
All modes allowed
00
01
○
-
02
03
Function disabled
00
(factory setting)
○
01
Function enabled
Setting conditions
When the unit is restarted by
the remote control switch, the
temperature automatically changes
to the setting temperature of "F5"
or "F6".
Models:
RPF(I)-FSN2E
Not available, use at 00 conditions
Use at 00 conditions
Use as 00 conditions
Use as 00 conditions
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Models:
RPF(I)-FSN2E
Not available, use at 00 conditions.
This parameter defines the
sensitiveness of the motion
sensor. The amount of activity in
the room is assessed according
to a different scale based on this
setting.
Detailed information about the
operation of the motion sensor
can be found in the technical
documentation of the indoor units.
This function is used to select
the operation modes in which
the setting of C8 (use of remote
control switch sensor or remote
sensor on THM4 to control the
indoor unit) is enabled.
Use at 00 conditions
Condensation may occur around
air outlet during COOL/DRY
operation with horizontal air flow or
downward air flow for long periods.
This function is used to prevent
condensation by moving the
louvre swing angle to the third step
automatically for 30 minutes every
1 hour.
(In RPk units, this function is
activated by means of DSW2-4
instead of the k8 optional function)
Description
Publicidad
