Fein ASCM14 Manual De Instrucciones página 16

OBJ_BUCH-0000000126-002.book Page 16 Tuesday, March 11, 2014 11:29 AM
en
16
Changing the tool.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Mounting application tools
(ASCM18QX, ASCM14QX, ASCM18QXC,
ASCM14QXC) (figure 8).
Open the keyless drill chuck.
Afterwards, insert the desired application
tool.
Tighten the keyless drill chuck.
Mounting application tools
(ASCM18QX, ASCM14QX, ASCM18QXC,
ASCM14QXC) (figure 9).
Slide the sleeve frontwards.
Afterwards, insert the desired application
tool.
Slide the sleeve back again.
Fig. 8
Drill chuck
2.
Fig. 9
1.
2.
3.
3.
1.