Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting Up
Easy connections
TV
OPTICAL COAXIAL
IN
OUT
DIGITAL AUDIO
CONTROL
OUT
The setup described here is a basic setup
that allows you to play discs using just the
cables supplied with the player. In this setup,
stereo audio is played through your TV.
• This player is equipped with copy
protection technology. Do not connect
this player to your TV via a VCR using AV
cables, as the picture from this player
will not appear properly on your TV. (This
player may also not be compatible with
some combination TV/VCRs for the
same reason; refer to the manufacturer
for more information.)
1
Connect the VIDEO OUT and AUDIO
OUT (2ch) jacks to a set of A/V inputs on
your TV.
Use the supplied red/white stereo audio and
yellow video cable. Make sure you match up
the left and right audio outputs with their
corresponding inputs for correct stereo
sound.
A/V IN
(AUDIO)
AV CONNECTOR 1 (RGB)-TV
S400
L
CENTER
L
1
2
AUDIO OUT
(5.1ch)
R
SUB
R
WOOFER
AUDIO
FRONT
SURROUND
S-VIDEO
OUT
OUT
(2ch)
To power outlet
AV CONNECTOR 2
Y
1
2
P
P
B
R
VIDEO
COMPONENT VIDEO OUT
OUT
See the next page if you want to use a
different type of connection.
• If you need another pair of stereo
outputs (and don't need to use the
multichannel analog outputs), you can
use the AUDIO OUT (5.1ch) FRONT
L / R jacks (page 14).
2
Connect the supplied AC power cord
to the AC IN inlet, then plug into a power
outlet.
• Do not unplug the player from the power
outlet while it is switched on.
• Do not plug this player into a switched
power supply found on some amplifiers
and AV receivers.
AC IN
02
11
En
Publicidad
