Canon imageRUNNER ADVANCE 4251i Guía De Usuario página 20

•
Avoid installing the machine near televisions,
radios, or similar electronic equipment.
The machine might interfere with sound and picture
signal reception.
Insert the power plug into a dedicated power outlet,
and maintain as much space as possible between the
machine and other electronic equipment.
•
Contact an authorized Canon dealer if
communication is unavailable.
Depending on your locale or your telephone
connection, you may be unable to perform data
communication. In this case, contact your local
authorized Canon dealer.
•
Do not remove the machine's leveling feet.
Do not remove the machine's leveling feet after the
machine has been installed.
If you put weight on the front of the machine while
the drawers or units within the machine are pulled
out, the machine may fall forward. To prevent this from
happening, make sure that the machine's leveling feet
are in place.
•
Avoid installing the machine at high altitudes
of about 3,000 metres above sea level, or
higher.
Machines with a hard disk may not operate properly
when used at high altitudes of about 3,000 metres
above sea level, or higher.
■ Select a Safe Power Supply
•
Plug the machine into a 220 - 240 V AC outlet.
•
Make sure that the power supply for the
machine is safe, and has a steady voltage.
•
Do not connect other electrical equipment to
the same power outlet to which the machine is
connected.
•
Do not connect the power cord to a multiplug
power strip, as this may cause a fi re or
electrical shock.
•
The power cord may become damaged if it is
stepped on, affi xed with staples, or if heavy
objects are placed on it. Continued use of a
damaged power cord can lead to an accident,
such as a fi re or electrical shock.
•
The power cord should not be taut, as this
may lead to a loose connection and cause
overheating, which could result in a fi re.
18 Preface
•
If excessive stress is applied to the connection
part of the power cord, it may damage the
power cord or the wires inside the machine
may disconnect. This could result in a fi re.
Avoid the following situations:
-
Connecting and disconnecting the power cord
frequently.
-
Tripping over the power cord.
-
The power cord is bent near the connection part, and
continuous stress is being applied to the power outlet
or the connection part.
-
Applying excessive force on the power plug.
■ Moving the Machine
•
If you intend to move the machine, even to a
location on the same fl oor of your building,
contact your local authorized Canon dealer
beforehand. Do not attempt to move the
machine yourself.
■ Provide Adequate Installation Space
Provide enough space on each side of the machine for
unrestricted operation.
•
When the Color Image Reader Unit-H1 is
attached:
100 mm or more
1,094 mm
•
When the Color Image Reader Unit-H1, Inner
Finisher-D1, and Paper Deck Unit-B2 are
attached:
100 mm or more
1,406 mm
1