INSTALLATION INSTRUCTIONS
Determine the location for the fi xed wall bracket.
Mark the hole locations for the wall anchors.
Drill the holes and install the wall anchors.
Attach the fi xed wall bracket to the wall with the screws.
Handshower Connector
Fixed Wall Bracket
Insert a washer into the elbow connector end of the shower hose.
Attach the shower hose to the supply elbow. Run cold and hot water through the shower hose to fl ush out
dirt and debris.
Insert the other washer into the threads of the handshower connector.
Thread the handshower into the shower hose. Tighten with an adjustable wrench.
Turn on the water. Check for leaks and smooth operation.
Place the handshower in the fi xed wall bracket.
1188577-2-E
4 of 5
2. INSTALL THE FIXED WALL BRACKET (P24453)
Drill holes using a 5/16" bit.
13/16"
(21 mm)
Press and hold
legs together.
3. INSTALL THE HANDSHOWER AND HOSE
Handshower
Washer
Handshower, Hose
& Handshower Accessories
Anchor
Fixed Wall Bracket
Supply Elbow
Washer
Elbow Connector
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com
Screw