Publicidad
2. Installation for 3-Way
IMPORTANT! Do not remove the internal plug from the valve
body. The plug connects the left and right ports, allowing either to
be used for an additional accessory.
Install 1/2" copper tubing or piping for all accessories. Securely
fasten the piping and outlet elbows to the framing.
Install temporary 1/2" nipples in the outlet elbows so that they
extend a minimum of 2" (51 mm) beyond the finished wall.
Turn on the water supply to the valve. Check for leaks and
proper operation. Once verified, turn off the water.
Install caps on the temporary bath and shower nipples.
Turn on the water supply. Check for leaks. Once verified, turn off
the water.
Complete the finished wall.
Install the trim according to the installation instructions packed
with the trim.
Kallista
Accessory Water Lines
1/2" Copper Tubing or Piping
Mixed Water Supply
3/4" Copper Tubing or Piping
5
1091987-2-E
Publicidad
