INSTALLATION INSTRUCTIONS
Ensure the valve stem adapter is fi rmly pressed onto the valve stem.
Secure the valve stem adapter to the valve with the correct length screw, as selected in the "Install the
Valve Stem Adapter" section of this guide.
Align the holes on the front plate assembly and the valve.
NOTE: Be sure to select the correct length screw for your application.
Attach the two screws through the front plate assembly and into the valve. Do not overtighten.
Visually inspect the front plate assembly to ensure the foam seal is completely covering the wall opening. If
not, stop the installation and repair the wall opening.
1091608-2-G
5 of 6
3. INSTALL THE FRONT PLATE
Screw
Valve Stem
Adapter
3-way Transfer Valve Trim
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Verify the seal covers
the wall opening.
Screw