Publicidad
INSTALLATION INSTRUCTIONS
1/2"
(13 mm)
Apply plumbers
putty.
Install a male 1/2" NPT pipe to extend 1/2" (13 mm) beyond the fi nished wall.
Apply sealant tape to the exposed threads of the pipe nipple.
Apply a bead of plumbers putty or other sealant to the back of the shower arm according to the putty
manufacturer's instructions.
Thread the shower arm to the pipe nipple.
Use a clean strap wrench to securely tighten the shower arm.
Remove any excess plumbers putty.
Turn on the water supply.
Run hot and cold water through the shower arm to fl ush out dirt and debris.
Unthread the shower arm adapter from the shower arm using the 9 mm hex wrench.
1226929-2-C
3 of 4
INSTALL THE SHOWER ARM
Finished Wall
Pipe Nipple
Thread Sealant
Shower Arm
Shower Arm
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Shower Arm
Adapter
Hex
Wrench
Publicidad
