Publicidad
Installation for 2-Way (cont.)
Install temporary 1/2" nipples in the outlet elbows so they extend
a minimum of 2" (51 mm) beyond the finished wall.
IMPORTANT! When testing P29513 operation, water should flow
as follows: Accessory 1, Accessories 1 and 2, Accessory 2. If water
flows as: Accessory 2, Accessory 2, Accessories 1 and 2; you will
need to remove the spacer, rotate the detent 180 degrees, then
reinstall the spacer.
IMPORTANT! When testing K-737 operation, water should flow as
follows: Accessory 1, Accessory 2. Combined functionality will not
work.
NOTE: For P29514 only: When the valve is turned midway
between the two outlet ports, water flow from the ports will reduce
to a trickle.
Turn on the water supply to the valve. Check for leaks and
proper operation. Once verified, turn off the water.
Install caps on the temporary bath and shower nipples.
Turn on the water supply. Check for leaks. Once verified, turn off
the water.
Complete the finished wall.
Install the trim according to the installation instructions packed
with the trim.
Kallista
7
1091987-2-E
Publicidad
