FUEL WARNING
No smoking when filling with gasoline.
Do not overfill. Full level is 1 in. below the
top of the fuel neck. Stop the engine for
five minutes before refueling to avoid the
heat from the muffler igniting fuel vapors.
ENGINE LUBRICANT WARNING
You must add lubricant before first operating
the generator. Always check the lubricant level
before each operation. The lubricant level should
always register between the hatched areas on
the dipstick. The unit is equipped with a sensor which will
automatically shut off the engine if the lubricant level falls
below a safe limit.
GROUNDING WARNING
This generator does not include a ground rod
or copper wire. Call a qualified electrician for
local grounding requirements.
CLEARANCE WARNING
While operating and storing, keep at least
3 feet of clearance on all sides of this
product, including overhead. Allow a
minimum of 30 minutes of "cool down"
time before storage. Heat created by
muffler and exhaust gases could be hot
enough to cause serious burns and/or
ignite combustible objects.
HOT SURFACE WARNING
Do not touch the muffler or aluminum cylinder of the engine.
They are very HOT and will cause severe burns. Don't put
any flammable or combustible materials in the direct path
of the exhaust.
SPARK ARRESTOR
Operation of this equipment may create sparks that can
start fires around dry vegetation. A spark arrestor may be
required. The operator should contact local fire agencies for
Note:
laws or regulations relating to fire prevention requirements.
1. Die cut information is noted in blue/cyan color.
2. Maximum allowable Lead content to be 90 PPM max
and Cadmium content to be 100 PPM max per TTI requirement.
3. Label must resist weather, gasoline, and oil per ANSI Z535/UL 969-1991.
Revision Changes:
1.
This drawing belongs to TTi Group North America. Its contents are confidential and proprietary and shall not be
disclosed to or used by or for outside parties without TTi Group North America's written consent.
SYMBOLS
Product does not include ground rod or copper wire. Call a qualified electrician for local
24 mm
grounding requirements.
El producto no incluye el alambre de cobre ni la barra de conexión a tierra. Comuniquese
con un electrista calificado para todo lo relacionado con los requistos de conexión a tierra.
940513028-01
OP
2013.08.12
Page 7 — English
100%
109.7 mm
WARNING
ADVERTENCIA
WARNING
HOT SURFACE
ADVERTENCIA
SUPERFICIES CALIENTE
Multiple
Special size +/-0.2mm
Illustrator (PDF)
940513028-01
Black + Pantone
Flexcon 21970
with Matte P.P.
or approved alternate
material
Pantone
152C