Publicidad
Idiomas disponibles
Idiomas disponibles
The remote control transmits signals to the system
Operating modes
1.
Select the mode
Each time the MODE button is pressed, the operation mode
changes in this sequence:
COOLING MODE: In this mode the room will be cooled, to
make you feel comfortable in the hot seasons.
HEATING MODE: Use this mode to warm your room and make
it comfortable in cold seasons
FAN MODE ONLY: Use this mode to ventilate your room, the air
conditioner operates like a fan.
Note:
Heating mode is not available for cooling air conditioners
●
only.
During the mode change, wait a few seconds and repeat
●
the operation if the unit does not respond.
To prevent cold air from coming out, allow 2-5 minutes to
●
preheat the indoor unit in the HEATING mode. The indoor
fan will not function during pre-heating.
2.
Set the fan speed
Each time the "FAN" button is pressed, the fan speed changes
in this sequence:
In the "FAN ONLY" mode, only the High, Medium and Low
options are available.
REMOTE CONTROL
3.
Set the Temperature
Press the + button to increase the temperature in 1 degree °C
intervals
Press the button - to decrease the temperature in intervals of 1
degree ° C
Press these two buttons and keep the button pressed to change
the temperature quickly.
Available temperature range:
*HEATING, COOLING
VENT ONLY
*NOTE: The heating mode IS NOT available on the Cooling
only Air conditioner.
4.
ON/ Off
Press this button to turn on or off the device.
16 °C – 30 °C
Cannot be configured
8
Publicidad
