Publicidad
Idiomas disponibles
Idiomas disponibles
Basic Operation
(continued)
Front Panel Indicator Lights
continued
"REPLACE BATT" LED: This red light will illuminate constantly and
the UPS alarm will beep every 2 seconds if your UPS's microprocessor
detects a battery fault or if your UPS fails the automatic self-test (after
you turn your UPS ON) and the UPS battery is less than fully charged.
Let the UPS system charge for at least 12 hours and perform a self test
using the "ON/TEST Button" as described on page 7. If the light continues
to stay on, contact Tripp Lite for service.
Rear Panel
Accessory Slot: Remove the small cover panel from this slot to use
optional accessories to remotely monitor and control your UPS. Contact
Tripp Lite Customer Support at (773) 869-1234 for more information,
including a list of available SNMP, network management and connectivity
products.
External Battery Pack Connector (configuration varies by model):
Use to connect optional Tripp Lite Battery Packs for additional runtime.
Contact Tripp Lite Customer Support at (773) 869-1234 for the
appropriate Tripp Lite battery pack to connect. Refer to instructions
available with the Battery Pack for complete connection information
and safety warnings.
Fan: The fan cools the UPS's internal components. It is always on when
line power is present.
Input Circuit Breaker Switch: This resettable breaker prevents high
input current from damaging the UPS or the attached load. If this
breaker trips, make sure your UPS is connected to AC power of the
proper voltage before resetting the circuit breaker by pushing the
breaker switch in.
Ground Screw: Use this to connect any equipment that requires a chassis
ground.
Output Circuit Breakers Switches: These resettable circuit breakers
protect your UPS from output overload. If one or both breakers trip,
remove some of the load on the circuit(s) and allow the UPS to cool
before pressing the breaker switch(es) in to reset.
10
201203257 93-2486.indd 10
4/3/2012 3:13:00 PM
Publicidad
