Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Important Safety Instructions
Connection and Start-Up (continued)
3
Turn the UPS ON:
• Press the ON/TEST Switch and hold it for
several seconds until you hear a beep
• Release the ON/TEST Switch. The ON LINE
LED will illuminate, and your UPS will begin
providing power to its AC outlets
Note: UPS system will function properly upon initial startup,
however, maximum runtime for the unit's battery will only be
accessible after it has been charged for 24 hours.
Your UPS will function properly without these Yoyr
Optional Connections
UPS will function properly without these connections.
Phone/Network Line
1
Suppression
Your UPS has jacks which protect against surges on
a telephone line or telephone/ network data line.*
Using appropriate telephone or network cords
connect your wall jack to the UPS jack marked
"IN." Connect your equipment to the UPS jack
marked "OUT." Make sure the equipment you
connect to the UPS's jacks is also protected against
surges on the AC line.
* Not compatible with PoE (Power Over Ethernet) applications.
201203257 93-2486.indd 5
(continued)
INPUT
BREAKER
5
3
ACC. SLOT
LOAD 1
IN
OUT
EPO
PHONE / DATA PROTECTION
1
Your model may differ.
OUTPUT
LOAD 2
RS-232
USB
WARNING
CAUTION
CONNECT 48 VD
Risk of electric shock
BATTERY SYSTEMS
See top of unit for
CONNECTING OTH
cautionary markings
SYSTEMS WILL VO
WARRANTY
4/3/2012 3:12:56 PM
Publicidad
