Publicidad
Idiomas disponibles
Idiomas disponibles
4.1 Treatment steps
Press the control button (#6). The device will turn on, the
1.
level 1 energy indicator light will be on, and a fan sound
will start.
After pressing the control button (#6), the ready/skin tone
2.
warning indicator light (#7) will turn on. The device is then
ready to use at the lowest energy level. Always start at
energy level 1 for your first treatment.
Set the energy level. Press the control button
3.
(#6) repeatedly to increase the energy level until you
have the level you want. The energy level indicator lights
(#5) indicate the energy level setting (see section 4.6
Energy levels). The number of energy level indicator lights
(#5) that are on, indicates the energy level selected.
Decide if you wish to treat the area by Pulsing or Gliding
4.
(refer to section 4.8 Pulsing and gliding).
5.
Apply the treatment surface
pulse button (#1). The device will first determine the
colour of your skin automatically. If the skin colour is light
enough for safe application, the device will activate the
galvanic energy. You will feel a mild sensation of warmth
and tingling, and you may hear a popping sound. This is
completely normal. The galvanic energy works to enlarge
your pores for a better application of the treatment.
If your hand does not touch the base electrode (#8) no
Z
galvanic energy will be emitted.
6.
Directly afterwards, the device will flash a pulse of light
onto your skin, and the ready/skin tone warning indicator
light (#7) will turn off. You will see a bright flash of light
and simultaneously hear a popping sound, which is a
normal noise for the device. You will feel a mild sensation of
warmth and tingling. The device will immediately recharge
for the next pulse.
(#2)
to the skin. Press the
19
EN
Publicidad
