Sportplus SP-WR-1800 Manual De Instrucciones página 45

Operation
Install 4 AA batteries with correct polarity in the battery compartment on the
computer (F) (see Step 11). The computer (F) beeps for 2 seconds.
Important notes:
1. The computer (F) activates automatically when you begin training or press a button.
2. After 4 min, the computer (F) automatically switches to standby mode when no
signal is received.
3. If the computer (F) displays no or only a partial image, replace the batteries.
Select one of 2 options to start the computer (F): Select quick start or training mode.
Quick start
1. Begin training.
2. A beep sounds.
3. The computer (F) switches to manual operation (MANUAL).
4. During training, the computer (F) continuously measured the values for: PULSE,
TIME, DISTANCE, SPM, CALORIE, STROKES, and TIME/500M.
5. Press the START/STOP button to take a break.
6. The display flashes STOP.
7. Press the START/STOP button to continue training.
8. Press the RESET button to return to standby mode.
Selecting the training mode
1. Press the MODE button to turn on the computer (F).
2. Press the UP button to select one of 3 training modes: MANUAL (manual training),
INTERVAL (interval training), or TARGET (target value training).
Manual training (MANUAL)
1. Press the UP button until the display flashes the MANUAL training mode.
2. Press the MODE button again to confirm the selected mode.
3. A beep sounds.
4. The display shows MANUAL.
5. Begin training.
6. During training, the computer (F) continuously measured the values for: PULSE,
TIME, DISTANCE, SPM, CALORIE, STROKES, and TIME/500M.
45