Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote. (Figure 1)
NOTE: Factory setting is all up. Do not use this position.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from or to
other remote units, simply change the combination code
in the remote and receiver.
WARNING
To avoid possible electrical shock, be sure electricity
s i
u t
n r
e
d
o
f f
t a
h t
e
m
a
(Figure 2).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION COULD
DAMAGE THIS RECEIVER.
2. Slide the receiver into the hanger bracket as shown in
Figure 3.
3. Connect wires using connectors as shown in Figure 4.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are in
place. Noise and motor damage could result.
How to Wire Your Ceiling Fan
n i
u f
s
e
b
o
x
b
e
o f
e r
w
r i
n i
WARNING
ON
1
g
Hanger Bracket
Receiver
L
N
AC POWER
11
Receiver Unit
Dip Switch
2
3
4
5
Figure 1
Figure 2
Figure 3
BLACK
WHITE
GROUND
HANGER
YELLOW
BRACKET
/ GREEN
HANGER
BALL
Receiver
Figure 4
RECEIVER HARDWARE USED:
WIRE
CONNECTORS
MAIN FUSE BOX
NOTE: Supply wires
omitted for clarity
BLUE
BLACK
/ WHITE
RED
GRAY
YELLOW
DC MOTOR
BLACK
ANTENNA
x 8
Publicidad
