How to Assemble Your Ceiling Fan Blades
1.
Remove the two set screws and locking nuts in the
downrod support of the motor assembly and retain
for reinstallation in Step 4 of Page 8. Disassemble the
upper housing cover by removing the six screws at the
top of the motor assembly and retain for Step 3.
Carefully twist and lift off the cover. (Figure 1)
2. Slide blades through slots in motor housing and att
to the motor hub using the #8-32 serrated head screws
and flat washers. Make sure the screws securing the
blades to the motor hub are tight and are properly seated.
Figure 2)
(
NOTE:
Periodically check blade hardware and
resecure if necessary.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
3.
Reassemble the upper housing cover to the motor
assembly using the previously removed screws.
(Figure 3)
HARDWARE USED:
#8-32
SERREATED HEAD
SCREWS
FLAT WASHER
Upper Housing
Cover
7
Upper Housing
Cover
Figure 1
Motor Assembly
#8-32 Washer Head Screw
with Flat Washer
(3 per assembly)
Blade
Figure 2
x 15
x 15
Motor Assembly
Figure 3