Publicidad
Idiomas disponibles
Idiomas disponibles
Hazard switch (FES125A/150A)
Hazard switch is over to start button.This
system should be used only when your
scooter is stopped under emergency or
hazardous conditions. To turn it on, turn the
ignition key to the ON position, and then
slide the switch marked
rear turn signals will blink simultaneously.
All of the turn signals can blink without the
ignition key.
To operate this function, proceed as
follows:
1. Turn the ignition key to ON position and
then slide the hazard switch (1) to the
marked position.
2. All of the turn signals will keep blinking
even after you turn the ignition key to
OFF position.
3. You can turn off the turn blinking signals
by sliding the hazard switch back to the
off position.
50
All manuals and user guides at all-guides.com
.The front and
If the switch is left in the off position for
more than two seconds and then moved
back to the
signals will not be on.
Be sure to turn the switch off when the
hazard warning is no longer required, or the
turn signals will not work properly, and may
confuse other drivers.
If all the turn signals are left blinking with the
engine stopped, the battery will be
discharged.
(1) Hazard switch
position again, the turn
(1)
Publicidad
