Titan RX-80 Instrucciones De Uso página 3

• Contact your coating material supplier about the compatibility of material
with aluminum.
HAZARD: GENERAl
This product can cause severe injury or property damage.
• Read all instructions and safety precautions before operating equipment.
• Never spray near sources of ignition; e.g. open flames, cigarettes — also
cigars and pipes are sources of ignition —, sparks, hot wires and hot
surfaces, etc.
• Wear respiratory equipment when spraying. The operator must be provided
with a protective mask.
In order to prevent work related illness, the manufacturer's regulations for
the materials, solvents, and cleaning agents used must be observed when
preparing, working with and cleaning the unit. Protective clothing, gloves,
eyewear, and, in certain cases, protective skin cream are necessary to protect
the skin.
• Follow the coating material and solvent manufacturer's warnings and
instructions.
• Extraction equipment should be installed by the user in accordance with
local regulations.
• The objects being sprayed must be earthed.
• Before each use, check all hoses for cuts, leaks, abrasion or bulging of cover.
Check for damage or movement of couplings. Immediately replace the hose
if any of these conditions exist. Never repair a paint hose. Replace it with
another grounded high-pressure hose.
• Pulling the trigger causes a recoil force to the hand that is holding the spray gun.
The recoil force of the spray gun is particularly powerful when the tip has
been removed and a high pressure has been set on the airless high-pressure
pump. Therefore, when cleaning without tip set the pressure control valve
to the lowest pressure.
• Use only manufacturer authorized parts. User assumes all risks and liabilities
when using parts that do not meet the minimum specifications and safety
devices of the spray gun manufacturer.
EXPloSIoN PRotEctIoN IDENtIFIcAtIoN
X mARkING:
the spray gun corresponds with Ex II 2G IIc c t6 X and is, in accordance
with Directive 2014/34/Eu, suitable for use in explosion-hazardous
areas—as of type Zone 1. under certain circumstances, the unit itself may
cause the Zone 1 condition to be in effect.
RX-80
3
GB