Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads. Rub in direction of the grain line to
avoid scratching the surface.
Always wipe dry to avoid water marks.
• Stainless Steel Cleaner and Polish.
• Mild liquid detergent and water.
• Wipe with damp soft cloth or non abrasive sponge, then rinse
with clean water and wipe dry.
• Do not use chlorine base cleaners.
Metal Filters and Drip Trays:
1 Use 2 hands to remove filters.
2 Grasp filter handles, pull toward the front of range hood and
pull down on the rear handle to remove. Repeat for each filter.
A
A. Grease filter
3 Remove grease drip tray.
A
A. Drip tray
4 Wash metal filters and grease trays as needed in dishwasher
or hot detergent solution to clean.
5 Replace grease drip tray.
6 Reinstall filters, grasp filter handles and place front edge of
filter into the hood.
7 Push up on the back handle and set rear of filter into the drip
tray to secure. Repeat for each filter.
A
A. Grease filter
10
Replacing a LED Lamp
Turn off the range hood and allow the LED lamp to cool.
To avoid damage or decreasing the life of the new lamp, do
not touch lamp with bare fingers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1 Disconnect power.
2 Push up on the lens and turn it counterclockwise.
3 Remove the lamp and replace it with a 120-volt, 7.5 W watt
maximum halogen lamp with a GU10 base. Turn it clockwise to
lock it into place.
4 Repeat steps 2-3 for the other lamps if needed.
5 Reconnect power.
Publicidad
