Publicidad
Idiomas disponibles
Idiomas disponibles
5.6
Securing the burner to the boiler
Provide an adequate lifting system of the burner.
To install the burner on the boiler, do the following:
if necessary, widen the insulating gasket holes (Fig. 10), tak-
ing care not to damage them.
The burner can be fixed with the variable position (A) as shown
in Fig. 11.
Model
RS4D - RS5D - RS5DF
RS5D TL
Fix the flange 5)(Fig. 12) to the door of the boiler 1)(Fig. 12)
placing the insulating gasket 3) in between using the screws
4) and (if necessary) the nuts 2), but keeping one of the two
top screws 4)(Fig. 12) loose.
Insert the combustion head of the burner into the flange
5)(Fig. 12), tighten the flange with the screw 6), then lock the
screw 4)(Fig. 12) which was loose.
In any event, make sure that the combustion head
crosses the entire thickness of the boiler door.
WARNING
20141174
A (mm)
225 203
382 360
6
S7002
S7741
Installation
The seal between burner and boiler must be
airtight.
WARNING
Tab. H
1
3
5
4
16
GB
D5012
A
D5011
2
Fig. 10
Fig. 11
Fig. 12
Publicidad
