Ej Report Reading And Resetting; Printing Journal Data On The Way Of A Transaction; Reading And Resetting The Electronic Journal Data (Issuing Ej Report) - Sharp XE-A302 Manual De Instrucciones

EJ REPORT READING AND RESETTING

The cash register provides an electronic journal (EJ) function. This function is intended to record the journal
data in a memory instead of journal paper, and print the data as an EJ report. The register records the journal
data in REG, PGM, VOID, X1/Z1 and X2/Z2 modes. For details of EJ programming, please refer to "Electronic
journal (EJ) function parameters" section

Printing journal data on the way of a transaction

You can print journal data of a current transaction recorded in EJ memory by pressing the
transaction.
This function is valid when the printing style is programmed to receipt, and the receipt ON/OFF
function is set to OFF.
• Sample print

Reading and resetting the electronic journal data (Issuing EJ report)

You can read the journal data stored in the EJ memory in the journal format by executing the following
procedure in the X1/Z1 or OP X/Z mode.
To read all of the data:
e
(X1/Z1 mode only)
700
To reset all of the data:
700
To read the last 10 records:
710
• On the EJ memory, a maximum of 3000 lines of data can be
stored. When executing all data reading, all of the data stored
in the EJ memory will be printed. To save paper, compression
print is available.
• To stop reading or resetting the data, turn the mode switch to
"MGR" position. The data will not be erased when resetting.
• When printing is performed continuously, the printing may be intermitted several seconds. After the
intermission, the printing will be restarted.
66
(page
EJ report title
EJ report end title
@ A
P @ A
@ A
50).
• Sample EJ report
R
key during the
Header
information
print