Adjusting Nylon Line; Connecting Charger To Power Supply; Charging The Battery - Stihl FSA 65 Manual De Instrucciones

English

Adjusting Nylon Line

Adjusting Nylon Line
Hold the rotating mowing head
N
above the ground – tap it on the
ground once – about 1.2 in. of fresh
line is advanced.
2
1
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 1.0 in.
If the line is shorter than 1.0 in:
Switch off the trimmer.
N
Move the retaining latch to ƒ and
N
remove the battery.
Turn the trimmer on its back.
N
Press down the cap on the spool as
N
far as stop.
Pull the ends of the lines out of the
N
spool.
If the spool is empty, see "Replacing
Nylon Line".
14
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
2
Connect the charger to the power
1 N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between +5°C to +40°C (+41°F to
+104°F)
Only charge dry batteries. Allow a damp
battery to dry before charging.
Push the battery (1) into the
N
charger (2) until noticeable
resistance is felt – then push it as far
as stop.
2
FSA 65, FSA 85