Using The Unit - Stihl FSA 65 Manual De Instrucciones

After Finishing Work
Always clean dust and dirt off the power
tool – do not use any grease solvents for
this purpose.
MAINTENANCE, REPAIR AND
STORING
If you make a warranty claim for a
component which has not been serviced
or maintained properly or if
nonapproved replacement parts were
used, STIHL may deny coverage.
WARNING
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Strictly follow the maintenance and
repair instructions in the appropriate
section of your instruction manual.
Please also refer to the maintenance
chart in this manual.
Always switch off the
motor, move retaining
latch to ƒ, remove the
battery from the power
tool and make sure that
the cutting attachment is
stopped before doing any
maintenance or repair
work, such as replacing
the cutting attachment, or
cleaning the power tool.
This avoids the risk of the
motor starting
unintentionally.
FSA 65, FSA 85
WARNING
Do not attempt any maintenance or
repair work not described in your
instruction manual. Have such work
performed by your STIHL servicing
dealer only.
WARNING
Never repair damaged or broken heads.
This may cause parts of the cutting
attachment to come off and result in
serious or fatal injuries.
Tighten all nuts, bolts and screws after
each use.
Regularly check the electrical contacts
and ensure that the insulation of the
power cord and plug of the charger is in
good condition and shows no sign of
aging.
Electrical components, e.g. power cord
of charger, may only be repaired or
replaced by a qualified electrician.
Clean plastic components with a cloth.
Do not use aggressive detergents. They
may damage the plastic.
Do not spray the machine with water.
Do not clean your machine with a
pressure washer. The solid jet of water
may damage parts of the machine.
Keep the battery guides free from
foreign matter – clean as necessary.
Store the power tool in a dry, locked
location with the retaining latch on ƒ,
the battery removed and out of reach of
children.

Using the Unit

Mowing
Hold the unit with both hands – one
N
hand on the control handle – one
hand on the loop handle.
Stand upright – hold the power tool
N
in a relaxed position.
Make sure the cutting attachment is
N
not touching the ground or any other
objects.
Swing the trimmer back and forth in
N
an arc.
The cutting height is determined by
N
the distance of the mowing line from
the lawn surface.
Avoid contact with fences, walls,
N
rocks, etc. since it will result in a
higher rate of wear.
English
11