Xylem FLYGT CCD 401 Manual De Instrucciones página 16

en - Original instructions
Terminal
DI4
– Connect the 4-20 mA analog input device to the terminals.
Terminal
AI1
AI2
For more information about the terminals, see
4. Connect the power leads to the power input terminals.
5. Connect the signal ground (chassis ground) to the external chassis ground.
For more information about the terminals, see
6. Turn on the power of the equipment and if necessary, the separate power supply.
7. Configure the connected devices.
For more information, go to the support site at xylem.com/avensor.
3.3 Check the mobile connection
The unit is turned on.
1. Check the network signal strength.
LED
The state of LED must be solid green to avoid the connectivity problems.
2. If the signal strength is too low, move the external antenna to another position.
For more information, see
3. Check the connection to the cloud service.
LED
The connection procedure takes maximum 15 minutes.
The unit must not be disconnected during the connection procedure.
4 Troubleshooting
4.1 Symptoms and remedies
16
Description
Digital input 4
Description
Analog input 1
Analog input 2
Terminals
Terminals
State
Solid green
Solid red
Unlit
Terminals on page 18.
State
Blink or solid yellow
Unlit
on page 18.
on page 18.
Description
Excellent or good signal strength
Medium or fair signal strength
Poor or no signal
Connection
Yes
No