Westinghouse WP2500 Manual Del Propietário página 29

3. Point the thermo valve away from the work area
you are washing to avoid being sprayed with warm
water.
Figure 34 – Pump Thermo Valve WP2500
Figure 35 – Pump Thermo Valve WP2800
4. Move the engine stop switch down to the ON (I)
position (see Figure 36).
OPERATION
Figure 36 – Engine Stop Switch ON Position
5. Press the primer bulb three times (see Figure 37).
Figure 37 – Starting the Engine
1 - Primer Bulb
6. Firmly grasp and pull the recoil handle slowly until
you feel increased resistance. At this point, apply a
rapid pull on the recoil handle (see Figure 37).
N OTE: If the engine starts briefl y and then shuts off,
squeeze the trigger on the spray gun to relieve
the pressure before trying to start the engine
again.
7. Once the engine starts, allow the engine to warm
up slightly before beginning washing.
2
1
2 - Recoil Handle
29