Preparation; Inserting Batteries In The Remote Control; Battery Information; Remote Control Use - Sharp FU-P60S-E Manual De Uso

PREPARATION

INSERTING BATTERIES IN THE REMOTE CONTROL

• The battery life is about 1 year.
• The batteries for this remote control are for initial use only . Change the batteries
when necessary.
• Incorrect usage of the batteries may cause battery fluid leakage and/or damage.
Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones of the same
type. (Use 2 AA manganese batteries.)
• When not using the unit or remote control for an extended period, remove the
batteries.

REMOTE CONTROL USE

Operate the remote control facing the main unit
•
receiver.
• The signal range is about 23 feet (7m).
• Make sure there are no objects blocking the
path of the signal.
• A beep sound will be heard from the main unit
when a signal is received.
NOTE
• Avoid dropping or damaging the remote
control, using in a high humidity condition, in
direct sunlight or near a heat source.
Remove the back cover
1
Press and slide the back cover to
remove.
Insert batteries
2
Insert batteries with
shown below.
3
Close the back cover

Battery Information

Transmitter
E-5
and as
Receiver