SportDOG SportTrainer SD-1825E Manual De Funcionamiento página 12

TO MANUALLY PROGRAM THE REMOTE TRANSMITTER'S ID CODE FOLLOW THESE STEPS:
1. Turn the intensity dial to level 8, fl ip the toggle switch up, and then press and release the mode button on the
back of your Remote Transmitter. This does not change the mode, so the current mode will still be active after
the ID change is complete.
2. Once the mode button is released, the green indicator light will illuminate and stay on for 15 seconds.
3. While the green light is on, turn the intensity dial to select the 1st digit of the ID and then press and release the
side button. The green light will fl ash rapidly confi rming selection.
4. Again, while the green light is on, turn the intensity dial to select the 2nd digit of the ID and then press and
release the side button. The green light will fl ash rapidly confi rming selection. The 2nd digit is optional, and if
not desired, just wait until the green light turns off and refrain from pressing the side button.
5. At the end of 15 seconds, or after the second press of the side button, the green light will turn off and the
ID/frequency of the unit will be updated. At this point, the unit will be in the same mode it was in prior to
setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter. See Step
6 on page 13.
NOTE: If you press the side button only once (skipping Step 4) the ID is still a two digit ID. The left digit is defaulted
to 1. For example, if you selected 6 in Step 3 and pressed the button only once, the ID you get will be 16.
To return the unit to the factory ID either remove the battery or follow these steps:
1. Turn the intensity dial to level 8, fl ip the toggle switch up, and then press and release the mode button
on the back of your Remote Transmitter. This does not change the mode, so the current mode will still
be active after the ID change is complete.
2. Do not press any buttons and wait until the green indicator light turns off.
3. You will now need to match the Collar Receiver to the Remote Transmitter. See Step 6 on page 13.
TOGGLE SWITCH IN THE DOWN POSITION
MODE UPPER BUTTON
FUNCTION
1
Continuous
stimulation (Level set
by intensity dial)
2
Continuous
stimulation (Level set
by intensity dial)
3
Continuous
stimulation (Level set
by intensity dial)
4
Continuous
stimulation (Level set
by intensity dial)
5
Dog 1 (Level set by
intensity dial)
12
LOWER BUTTON
FUNCTION
Momentary stimulation
(Level set by intensity
dial)
Low Continuous
stimulation (Level set by
intensity dial)
Tone w/ one second
delay Continuous
stimulation
Low Continuous
stimulation (Level set by
intensity dial)
Dog 2 (Level set by
intensity dial)
WWW.SPORTDOG.COM
SIDE BUTTON TOGGLE
FUNCTION SWITCH
(up/down)
Vibration only Dog 1 /
Dog 2*
Programmable Dog 1 /
Continuous Dog 2*
stimulation**
Vibration only Dog 1 /
Dog 2*
Vibration only Continuous/
Momentary
Dog 3 (Level Continuous/
set by intensity Vibration
dial)
NUMBER
OF DOGS
2
2
2
1
3