Troubleshooting; Test Light Instructions - SportDOG SportTrainer SD-1825E Manual De Funcionamiento

TROUBLESHOOTING

The answers to these questions should help you solve any problem you have with this system. If they do not,
please contact a Customer Care Centre. For a listing of telephone numbers in your area, visit our website at
www.sportdog.com.
My dog is not responding when I press
a button.
The Collar Receiver will not turn on.
The Collar Receiver is not responding
to the Remote Transmitter.

TEST LIGHT INSTRUCTIONS

NOTE: If the Test Light does not fl ash, recharge the battery and re-test. If the Test Light still does not fl ash, contact
a Customer Care Centre.
16
• Check to see if the Collar Receiver has been turned on.
• If your range has reduced from the fi rst time you have used
it, please check to see if the battery is low in either the Remote
Transmitter or Collar Receiver.
• Many factors can impact the range you have with the
SportTrainer
"How the System Works".
• You can verify the Collar Receiver is delivering stimulation to
your dog by placing the test light, enclosed in your kit, on the
Collar Receiver. Please refer to the "Test Light Instructions"
section for details.
• Increase the Intensity Dial. Refer to "Find the Best Intensity
Level for Your Dog" for more information.
• Increase the Stimulation Range. Refer to "Changing Stimulation
Ranges" for more information.
• Make sure the Collar Receiver's Contact Points are placed
snugly against your dog's skin. Refer to "Fit the Collar Receiver"
for more information.
• You may need to switch to the longer Contact Points included
with your system or trim the hair beneath the Contact Points.
• If you notice your operating time dropping to about half the
original time, your Collar Receiver battery needs to be replaced.
Contact the Customer Care Centre to purchase a new one.
• Make sure the Collar Receiver has been charged. The Collar
Receiver will charge in 2 hours.
• Verify the Collar Receiver has been turned on. Refer to "Turning
the Collar Receiver On and Off".
• Refer to "Match the Collar Receiver."
1. Turn the Collar Receiver on.
2. Hold the Test Light Contacts to the Contact Points.
3. Press a Stimulation Button on the Remote Transmitter.
4. The Test Light will fl ash.
NOTE: At higher Stimulation Levels, the Test Light will fl ash brighter.
5. Turn the Collar Receiver off.
Save the Test Light for future testing.
WWW.SPORTDOG.COM
® 1825E. For a list of these factors, please refer to