Program The Collar Receiver For Three-Dog Operation - SportDOG SportTrainer SD-1825E Manual De Funcionamiento

C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
fl ashes 5 times.
3. Program the second Collar Receiver the same way using A through D above, but with the toggle
switch to the DOWN (BLACK) position and your Remote Transmitter programmed to mode 1, 2, 3, 6 or 7
(see page 12).
____________________________________________________________________________
PROGRAM THE COLLAR RECEIVER FOR
THREE-DOG OPERATION
A SportDOG
1. Program the Remote Transmitter to mode 3 in the UP position or mode 5 in the DOWN
position (see pages 11-12).
2. Then fl ip the toggle switch to the UP(ORANGE) position.
3. Program the fi rst Collar Receiver:
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in
4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin
its normal fl ashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
fl ashes 5 times. You may need to hold both units 60-90 cm (24"-36") from each other. If the Receiver
Indicator Light does not fl ash 5 times, start over and repeat from A.
4. Program the second Collar Receiver using A through D above, but using the Lower Button in
place of the Upper Button.
5. Program the third Collar Receiver using A through D above, but using the Side Button in place of
the Lower Button.
14
™ Add-A-Dog ® Collar Receiver must be purchased to train a third dog in three-dog mode.
WWW.SPORTDOG.COM