Oster BVSTEM7701 Manual De Instrucciones página 11

6. When the milk has doubled in volume, or, if you are using a beverage thermometer,
when the milk has reached 38°C (100°F), insert the frothing aid deeper into the milk
to further heat the milk. Do not heat milk above 65°C (150°F). To avoid splattering
of hot milk, do not let the tip of the frothing tube go above its surface. After frothing is
completed, turn the control knob back to the coffee/off position "
NOTE: If you wish to use the unit for another function, press again the steam button
" " to exit this feature, wait until the control panel lights (4 lights in the center)
become solid blue and then press the button for the new function you wish to use.
7. You are now ready to make cappuccino. REMEMBER: It is 1/3 espresso, 1/3
steamed milk and 1/3 frothed milk. Pour the espresso into a cup, which has the
capacity for at least 150 mL (5 ounces). Then add the steamed milk to the espresso
and spoon on the frothed milk on top.
8. Turn unit off "O" and unplug it from the electrical outlet. Allow the unit to cool.
9. Follow the instructions on "Cleaning your Espresso/Cappuccino Maker" section for
instructions on how to flush out any residual milk from the frothing tube. It is important
to properly clean your frothing tube and wash its removable cap after each use to
ensure it continues to work properly.
T HE H OT WATE R F UNCT I ON
The hot water function helps you conveniently prepare hot beverages
such as teas, instant coffee, instant hot chocolate and more:
1. Press the hot water button "
cup or container under the hot water nozzle and activate the
hot water function by turning the control knob down to the hot
water setting (see figure 17).
2. Once you have dispensed the required amount of hot water
into the cup or container, stop the hot water by turning the
control knob up to the coffee/off position "
NOTE: If you wish to use the unit for another function, press
again the hot water button "
the control panel lights (4 lights in the center) become solid
blue and then press the button for the new function you wish
to use.
3. Remove the cup or container and swing the hot water wand
over the drip tray to catch any drips of water.
CAUTION: do not touch the metal tube; use the black rubber
ring instead to move the wand.
C L E AN ING YOU R E SP R E SSO MA KER
1. Turn the side knob to the brew/off position "
the off position "O" an unplug the power cord from the electrical outlet.
2. The frothing tube may still be hot. Do not touch it with your hands until it has cooled.
Remove and wash the removable frothing tube cap and wipe frothing tube with a
damp cloth. Using the wrench built into the measuring spoon, unscrew the frothing
tube tip and clean the frothing tube valve with a needle or toothpick.
3. The water reservoir, filters, drip tray and drip grid can be washed with soapy water
or placed in the top rack of your dishwasher (avoid washing the porta-filter in your
dishwasher).
CAUTION: Do not immerse appliance in water.
" (see figure 16). Place the
".
" to exit this feature, wait until
", switch the red button on the back to
En glis h-10
".
Figure 16
Figure 17