Oster BVSTEM7701 Manual De Instrucciones página 6

BE FO R E US I NG YO U R ES P R E SSO
M AKER FO R TH E FI R S T T IME
CLEANING AND PRIMING THE UNIT PRIOR TO FIRST USE
Please refer to the "Description of the Appliance" section to familiarize with the
product and identify all parts.
1. Turn the side knob to the coffee/off position "
the on/off "I/O" button located in the back of the unit. Make sure it is unplugged from
the electrical outlet.
2. Remove stickers and labels from the unit.
3. First remove and then wash the water reservoir, porta-filter, filters and measuring
scoop in a mixture of mild detergent and water. Rinse each thoroughly and place
them back into the unit.
4. Refer to the instructions below on "How to Use the Espresso Function" before
removing the porta-filter and filter from the unit.
5. To clean the inside of the appliance, follow the steps listed on the "How to Use the
Espresso Function" section using water only. Do not immerse the appliance in water
or attempt to reach any of its internal parts.
IMPORTANT
To prime the pump, run the steam cycle for 30 seconds by following the steps below:
1. Fill water reservoir between the "Min" and "Max" levels.
2. Select one of the filters and place it on the porta-filter. Place the porta-filter in the unit
ensuring it is properly locked and place a cup under it.
3. Plug the appliance into the appropriate outlet.
4. Turn the power button on "I".
5. The control panel lights (4 lights in the center) will start blinking. Once these lights
become solid blue, press the steam button "
illuminate).
6. Place a cup half full with water under the frothing tube. Make sure the tip of the
frothing tube is submerged in the water.
7. Turn the control knob to the steam "
8. Let it release steam into the water for about 30 seconds and then turn the side control
knob down to the coffee/off position "
Now your unit has been primed and is ready to be used.
", switch the unit off "O" by pressing
" (the steam button "
" position.
".
E ng lis h-5
" light will