Bluetooth Function - Teac SL-D800BT Manual Del Usuario

Bluetooth function

Pairing fails.
e Refer to the Bluetooth device's operation manual.
e Put this unit into standby and turn the other Bluetooth
device off and on once. Then, try pairing again.
e Turn off all Bluetooth devices other than the one you
are trying to pair the unit with.
e After deleting the "SL-D800BT" data from the other
Bluetooth device, try pairing again.
Cannot connect.
e Confirm that the other Bluetooth device is on and its
Bluetooth function is enabled.
e Are the unit and the other Bluetooth device too far
apart?
Is there a wall or other obstruction between them?
As much as possible, use them close together in an
environment without obstructions.
e Put the unit into standby and then on again.
e Unpair the "SL-D800BT" from the Bluetooth device
and follow the instructions in "Pairing with another
Bluetooth device" on page 26.
The touch pairing reader does not work.
e Press the Bluetooth function button on the unit. When
using the remote control, press the FUNCTION button
repeatedly until the Bluetooth indicator lights.
e Check the settings of the other device that you are
using.
The sound skips or there is noise.
e Is there a wireless LAN, other Bluetooth device, micro-
wave oven or similar electronic equipment nearby?
Keep such devices as far away as possible.
e Reduce the distance between the other Bluetooth
device and this unit during use.
e Try moving the other Bluetooth device and this unit.
34
Troubleshooting (continued)
Radio
A station cannot be received. The reception is poor.
e Tune in the station properly.
e If FM broadcast reception is poor, try relocating the FM
antenna.
e If AM broadcast reception is poor, try changing the
orientation of the AM antenna.
e If a TV is near the unit, turn the TV off.
FM stereo broadcasts become mono.
e Press the FM MODE button to select stereo.
e The signal from the station might be poor. Adjust the
position of the FM antenna.
Since this unit uses a microcontroller, external noise
and other interference can cause the unit to malfunc-
tion. If this should occur, unplug the power cord from
the outlet and wait for about 20 minutes. Then plug
the power cord in and try the operation again.