Troubleshooting; Mp3/Wma Files - Teac SL-D800BT Manual Del Usuario

If you experience a problem with this unit, please check
the following items before requesting service. Something
other than this unit could also be the cause of the prob-
lem. Please also check that the connected devices are also
being used properly.
If it still does not operate correctly, contact the retailer
where you purchased the unit.
The unit will not turn on.
e Confirm that the power plug is plugged into a work-
ing outlet. Then, press the STANDBY/ON button to
turn the unit on. Confirm that there is power to the
outlet by plugging in another device such as a desk
lamp or tabletop fan (page 14).
There is no sound.
e Turn the VOLUME knob right to raise the volume.
Remote control does not work.
e Press the main unit's STANDBY/ON button to turn it
on.
e If the battery is dead, replace it with a new one.
e Clear obstructions that are between the remote con-
trol unit and the main unit. Use the remote control
unit within the 5 m (16 ft) range and pointed at the
front panel.
e If a lamp or other strong light source is near the unit,
turn the light source off.
A nearby TV or other device is malfunctioning.
e Some TVs with wireless remote control functions
might malfunction in response to the operation of
this unit's remote control. In this case, turn the other
device off while using this unit's remote control.
There is noise.
e Place the unit as far away as possible from TVs,
microwave ovens and other devices that emit electro-
magnetic waves.

Troubleshooting

CD player
Playback is not possible.
e If the disc is upside down, reload it with the labeled
side up.
e If the disc is dirty, wipe it clean.
e Discs that do not have any recordings on them or
that have not been finalized cannot be played back.
Make sure that CD-R/CD-RW discs that you want to
play back have recordings on them and have been
finalized.
e Depending on disc quality and recording conditions,
playback of some CD-R/CD-RW discs might not be
possible.
e Programmed playback works with finalized discs only.
The sound skips.
e Vibrations will cause skipping. Place this unit in a sta-
ble location.
e If the disc is dirty, wipe it clean.
e Do not play any disc that is warped, deformed or
damaged.

MP3/WMA files

Playback is not possible.
e Check the file format. MP3 files are recognized by
the ".mp3" file extension and WMA files by the ".wma"
extension.
e The MP3/WMA file might be damaged.
e Confirm that the file format is one that this unit can
play back (page 7).
33