Tabla De Contenido; Before Use; Ai Function - Teac T-H500 Manual Del Usuario

Table of Contents
AI Function..................................................... 3
Connections and Rear Panel Overview .... 4
Antenna Installation ..................................... 5
Front Panel Controls and
Their Functions............................................ 6
Display ............................................................ 6
Listening to Radio Broadcast...................... 7
How to Preset Broadcasting Manually..... 7
How to Preset Broadcasting
Automatically............................................... 7
Sleep Timer .................................................... 7
Adjusting Current Time ................................ 8
Daily Timer ..................................................... 8
Filing................................................................ 8
RDS (Radio Data System) ............................ 9
Major Reception Symbols of RDS Data .... 9
RDS Display ................................................. 10
PTY Search .................................................. 10
Specifications.............................................. 10
Troubleshooting .......................................... 11

Before Use

Read This Before Operating
OPlace the unit on a hard flat surface.
OAvoid placing it in direct sunlight or
close to a source of heat. Also avoid
locations subject to vibrations and
excessive dust, heat, cold or moisture.
ODo not open the cabinet, as this might
result in circuitry damage or electrical
shock.
ODo not attempt to clean the unit with
chemical solvents, as this might damage
the finish. Use a clean, dry cloth.

AI Function

For more information, see the owner's
manual of the A-H500.
OIf you press the following buttons with AI
function of the amplifier on, you can
listen to radio broadcasting easily.
For example
If you press the following, without pressing
the stop button while listening to a tape,
you can listen to radio broadcasting.
Tuner: T-H500
band button (preset tuning mode)
Amplifier: A-H500
input selector to tuner
Remote control unit: RC-613
tuner button
band button
preset call button (˙ or ¥)
_ 3 _
IMPORTANT (for U.K. Customers)
DO NOT cut off the mains plug from this
equipment. If the plug fitted is not
suitable for the power points in your
home or the cable is too short to reach
a power point, then obtain an
appropriate safety approved extension
lead or consult your dealer.
If nonetheless the mains plug is cut off,
remove the fuse and dispose of the plug
immediately, to avoid a possible shock
hazard by inadvertent connection to the
mains supply.
If this product is not provided with a
mains plug, or one has to be fitted, then
follow the instructions given below:
IMPORTANT. DO NOT make any
connection to the larger terminal which
is marked with the letter E or by the
safety earth symbo ç or coloured
GREEN or GREEN-and-YELLOW.
The wires in the mains lead on this
product are coloured in accordance
with the following code:
BLUE: NEUTRAL
BROWN: LIVE
As these colours may not correspond
with the coloured markings identifying
the terminals in your plug proceed as
follows:
The wire which is coloured BLUE must
be connected to the terminal which is
marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN
must be connected to the terminal
which is marked with the letter L or
coloured RED.
When replacing the fuse only a
correctly rated approved type should
be used and be sure to re-fit the fuse
cover.
IF IN DOUBT - CONSULT A
COMPETENT ELECTRICIAN.