Checking The Network Settings; Subnet Mask; Ext. Vol Limit - Pioneer XW-NAC3-K Manual De Instrucciones

Playback with HOME MEDIA GALLERY inputs

Checking the network settings

You can check the following network settings
of this unit: the MAC address, the IP address,
the gateway IP address, the proxy server, the
Subnet mask, and the firmware version (for the
Home Media Gallery of this unit).
Before proceeding with the following steps,
check whether you have followed Steps from 1
to 2 at Setting up the network on page 27.
1 Select 'Information' and press ENTER to
confirm your selection.
The Firmware Version (for the Home Media
Gallery of this unit) screen appears.
2 Check the network settings.
Press / to switch the display. Each time
you press /, the display switches as
follows.
Firmware Ver.  MAC Address  IP
Address  Gateway IP  Proxy Server
 Subnet Mask
3 Press RETURN.
The Setup screen appears. To return to the Top
Menu screen, press RETURN again.
Note
1 Refer to Enjoying the Home Media Gallery on page 20.

Ext. Vol Limit

"Ext. Vol Limit" controls the maximum value
when adjusting the sound volume from an
external controller (Digital Media Controller
(DMC)). The maximum of volume is changed
from '50' into '30'.
Important
• When Home Media Gallery function is
selected and both the iPod/iPhone
connector ports is not connected, Ext. Vol
Limit works.
1 Press HOME MEDIA GALLERY.
2 Disconnect iPod/iPhone units from the
iPod/iPhone connector ports.
, and then  STANDBY/ON for
3 Press
three seconds to switch Ext. Vol Limit
between on and off.
When Ext. Vol Limit is on, 'Ext. Vol Limit On' is
displayed on this unit's display.
05
1
29
En