Section 2. Getting Ready To Sew; Connecting The Power Supply; Controlling Sewing Speed; Speed Control Lever - Janome 7360 Manual De Instrucciones

e
w
Operating Instructions:
The symbol "O" of a switch indicates the "off" position of a switch.
For appliances with a polarized plug (one blade wider than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way. If it does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.
w
q
r
y
t
q

SECTION 2. GETTING READY TO SEW

Connecting the Power Supply

Turn off the power switch.
Insert the foot control plug into the machine socket.
Insert the machine plug into the machine socket.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
q Power Switch
w Foot Control Plug
e Machine Socket
r Machine Plug
t Power Supply Plug
y Wall Outlet
WARNING:
While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts
such as the thread take-up lever, handwheel or
needle.
Always turn off the power switch and unplug from the
power supply:
– when leaving the machine unattended.
– when attaching or removing parts.
– when clearning the machine.
Do not place anything on the foot control, otherwise
the machine will run intermittently.

Controlling Sewing Speed

Speed control lever:

You can set the maximum speed by the speed control
lever.
q Slide the lever to the right for higher speed.
w Slide the lever to the left for slower speed.
Foot Controller YC-485EC-1 is used with this sewing
machine.

Foot control:

Sewing speed is varied by the foot control.
The harder you depress the foot control, the faster the
machine runs.
6