Adjusting The Stitch Length; Changing The Needle Drop Position - Janome 7360 Manual De Instrucciones

Adjusting the Stitch Length

Press the Down (–) key to decrease stitch length.
Press the Up (+) key to increase stitch length.
The stitch length can be varied from 0.0 to 5.0.
* Default setting is "2.2".
NOTE:
Reverse stitch length cannot be set longer than 2.5.

Changing the needle drop position

You can change the needle drop position of straight
stitching, i.e. patterns #01–05 and #07-09.
Press the Down (–) key to move the needle to the left.
Press the Up (+) key to move the needle to the right.
* Defaut setting is "3.5".
q Left needle position
w Center needle position
e Right needle position
1.0
0.0
q
28
2.2 5.0
3.5 7.0
w e