Descargar Imprimir esta página

Milwaukee 2733-20 Manual Del Operador página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

24. Trigger
25. Trigger lock
26. Cut-line indicator switch (not shown)
27. Dust chute
37
36
SPECIFICATIONS
Cat. No. ..................................................... 2733-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Recommended Ambient
Operating Temperature ..................... 0°F to 125°F
No Load RPM ..................................................5000
Arbor Size ......................................................... 5/8"
Blade Size ..................................................... 7-1/4"
Blade Thickness (Kerf) ............................. Max 1/8"
Weight ..........................................................28 lbs.
CAPACITIES
Miter Cuts
Max Height ..................................................... 2.2"
Max Width at 0° Miter...................................... 8.3"
Max Width at 45° Miter .................................. 5.8"
Bevel Cuts
Max Height at 0° Bevel ................................... 2.2"
Max Height at Left 45° Bevel .......................... 1.6"
Max Height at Right 45° Bevel ....................... 0.8"
Compound Cuts (45° Miter and 45° Bevel)
Left .............................................. 5.9" W at 1.6" H
Right ............................................ 5.9" W at 0.8" H
Workpiece Vertical Against Fence
0° Miter / 0° Bevel ........................ 3.6" W at 0.9" H
Left 45° Miter / 0° Bevel ............... 3.6" W at 0.8" H
Right 45° Miter / 0° Bevel ............ 3.6" W at 0.7" H
28. Dust bag
29. Slide rail lock
30. Bevel knob
24
35
34
Always lock the saw head and slide rails before
transporting and storing the tool. Only carry tools by
the carrying handles.
Saw Head
To lock, press and hold down the saw head and then
push in the lock-down pin.
To unlock, press and hold down the saw head and
pull out the lock-down pin. Raise the saw head.
Slide Rails
To unlock, loosen the slide rail lock by turning it
counterclockwise.
To lock, slide the saw head forward and tighten the
slide rail lock by turning it clockwise.
To prevent the tool from sliding, falling or tipping
from a raised work surface during operation, the saw
should be mounted to a supporting surface such as
a level, sturdy work table, bench, or miter saw stand.
Position the saw and workbench to allow adequate
room for cross-cutting long workpieces. To mount
the saw to a flat surface, insert fasteners through
the holes in the corners of the saw base and secure.
Follow manufacturer instructions when mounting to
a miter saw stand.
5
31. 0° stop pin
32. Hand stop
33. Wrench storage (not shown)
34. 6 mm Hex Wrench
35. Workpiece clamp sockets (2)
36. Spindle lock
25
37. Handle
26
27
32
33
ASSEMBLY
Transporting and Storing
Mounting the Miter Saw
28
29
30
31

Publicidad

loading