Publicidad
Idiomas disponibles
Idiomas disponibles
INOXPAN S.L.
WHAT TO DO IN CASE OF A PROBLEM
The hob or the cooking zone does not start:
•
The hob is badly connected to the electrical network.
•
The safety fuse is cut off.
•
The lock function is activated.
•
The sensitive touch keys are covered with grease or water.
•
An object is put on a sensitive touch key.
The control panel displays [ E ]:
•
Disconnect and reconnect the hob.
•
Call after sales service.
One or all cooking zone(s) cut off:
•
The safety system functioned.
•
This system works when you forgot to switch off the cooking zone.
•
One or more sensitive touch keys are covered.
•
The pan is empty and its bottom overheated.
•
The hob also has an automatic reduction of Booster level and breaking Automatic
overheating
The ventilation system is still working after switching the hob off:
•
This is not a failure, the fan continues to protect the electronic device.
•
The fan stops automatically.
The automatic cooking system does not start:
•
The cooking zone is still hot [ H ].
•
The highest Booster level is set [ 9 ].
The control panel displays [ C ] :
•
See chapter "Clean function".
The control panel displays [ II ]:
• See chapter "Stop&Go".
The control panel displays [ Π ] :
• See chapter "Bridge".
The control panel displays [
•
An object or liquid covers the control keys. The symbol disappears as soon as the key is
released or cleaned.
The control panel displays [ E2 ] :
•
The hob is overheated, let it cool and then turn it on again.
The control panel displays [ E8 ] :
•
The air inlet of the ventilator is obstructed, release it.
The control panel displays [ U400 ] :
•
The hob is not connected to the network. Check the connection and reconnect the hob.
The control panel displays [ Er47 ] :
•
The hob is not connected to the network. Check the connection and reconnect the hob.
If one of the symbols above persists, call the after sales service.
] or [ Er03 ] :
13
EN
Publicidad
