Publicidad
Idiomas disponibles
Idiomas disponibles
Never cut out the hole in the window slider kit.
EN
FR
Insert the exhaust hose through the window slider hole
Affix the exhaust hose outlet into the window slider and seal them tightly.
5. USE
The appliance can be controlled with the control panel or with the remote
control. On the following pages, operation is mainly described when using the
remote control.
1. Plug the air conditioner to an outlet, the appliance goes into standby mode.
2. Press the
3. Never turn the air conditioner off by unplugging from the mains. Always press
the
button, then wait for a few minutes before unplugging. This allows the
appliance to perform a cycle of checks to verify operation.
Notes:
-
To ensure the receiving effect, the remote control must be no more than
7 meters away from the air conditioner, and there should be no obstacles
between the remote control and the receiver.
-
Protect the room from direct exposure to the sun by partially closing curtains
and/or blinds to make the appliance much more economical to run.
-
Make sure there are no heat sources in the room.
Cool mode
Ideal for hot muggy weather when you need to cooling and dehumidify the room.
To set this mode correctly:
• Press the"
• Select the target temperature18℃-32℃(64℉-90℉) by pressing the "△"or "▽"
button until the corresponding value is displayed.
• Select the required fan speed by pressing the "
speed have different function.
High speed display "F2", low speed display "F1".
• F2 High
• F1 Low
The most suitable temperature for the room during the summer varies from 24℃
to 27℃. You are recommended, however, not to set a temperature much below
the outdoor temperature. This will cause unnecessary power consumption.
button to turn on the air conditioner.
"button a number of times until the "Cool" symbol light appears.
To achieved the temperature as fast as possible.
Run of the low noise.
Cut on opposite of hole
14
14
" button. Different fan
Publicidad
