Delta 36-322L Manual De Instrucciones página 12

TABLE HAZARD ZONE
THE AREA INSIDE THE TWO RED
LINES (A) FIG. 17 ON THE TABLE IS DESIGNATED
AS A HAZARD ZONE. NEVER PLACE YOUR HAND(S)
INSIDE THE "TABLE HAZARD ZONE" (WITHIN THE
RED LINES) WHILE THE TOOL IS BEING OPERATED.
CLAMP ALL WORKPIECES WHICH WOULD CAUSE
YOUR HAND(S) TO BE WITHIN SIX INCHES OF THE
SAW BLADE.
TILTING THE CUTTINGHEAD FOR BEVEL CUTTING
DISCONNECT MACHINE FROM POWER SOURCE.
A
IMPORTANT: Move the sliding fence to the left or right to provide clearance for the blade and guard. The DEGREE of
tilt determines how far to move the sliding fence. Refer to the section "ADJUSTING SLIDING FENCE."
1. The cuttinghead of your compound miter saw can be tilted to cut any bevel angle from a 90° straight cut-off to a 48° bevel
angle left. Raise bevel lock lever (A) Fig. 18.
2. Positive stops (A) Fig. 19 are provided to rapidly position the saw blade at 0°, 33.9° and 45°. Refer to the section of
this manual titled "SELECTING 0°, 33.9°, AND 45° BEVEL POSITIVE STOPS." The bevel angle of the cuttinghead is
determined by the position of the pointer (B) on the scale (C).
3. In addition, a marked indicator (D) is provided on the bevel scale (33.9°) for cutting crown moulding. Refer to the
"CUTTING CROWN MOULDING" section of this manual.
SELECTING 0°, 33.9°, AND 45° BEVEL POSITIVE STOPS
The bevel setting feature utilizes a sliding plate (A) Fig. 20, pin (B), and bushing (C) design that is used to select the bevel
angle. The position of the pin (B) and the sliding plate (A) determine the bevel angle.
DISCONNECT MACHINE FROM POWER SOURCE.
1. Position the bevel detente plate so that the desired angle (A) Fig. 20 is exposed immediately to the left of the housing (H)
Fig. 21.
2. Lift the bevel lock lever (A) Fig. 18 to disengage the bevel lock.
3. Tilt the cuttinghead left as desired until it stops on plate (A) Fig. 20. NOTE: Fig. 21 illustrates the sliding plate positioned
for 45° left.
4. Lower the the bevel lock lever (A) Fig. 18 to engage the bevel lock.
NOTE: To perform a bevel cut of more than 45°, pull the bevel pin (B) out to bypass the bevel detent plate. 48° is possible.
C
Make sure that the fence is clear of the guard and blade before operating the saw.
Fig. 18
A
B
Fig. 20
A
Fig. 17
A
Fig. 19
A
12
A
B
D
C
H
Fig. 21
H