Functional Description; Carton Contents; Unpacking And Cleaning - Delta 36-322L Manual De Instrucciones

FOREWORD
Delta Model 36-322L is a high capacity 12" single-bevel compound miter saw equipped with a laser guide and designed
to cut wood and non-ferrous metals. This machine is supplied with design features that increase the cutting capacity. This
machine can cut 6" base moulding mounted vertically, crosscut 2" x 8" dimensional lumber, miter 2" x 6" dimensional
lumber at 45° both left and right, and bevel 2" x 8" dimensional lumber left at 45°. It has positive miter stops at 0°, 15°,
22.5°, 31.62, and 45° both left and right, and bevel stops at 0°, 33.86°, and 45° left.
NOTICE: The photo on the manual cover illustrates the current production model. All other illustrations contained in
the manual are representative only and may not depict the actual color, labeling or accessories and are intended to
illustrate technique only.
1 - Miter Saw
2 - Dust bag
3 - Dust Spout
4 - Wrench
5 - 1/8" hex wrench
6 - 2mm hex wrench
7 - Open end 7/16" wrench
2

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from
all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household
floor paste wax. Place the machine on a firm, level surface with proper support of the workpiece. The 36-322L is shipped
with the cuttinghead at 90° and the table rotated 45° right. To release the head and move it to the operating position, see
"MOVING CUTTINGHEAD TO THE UP POSITION" and "MOVING TABLE TO THE 0° CUT-OFF POSITION" sections
in this manual.

FUNCTIONAL DESCRIPTION

CARTON CONTENTS

4
3 5
6
1
7
8