Franklin Electric SSP1 SmartStart Manual Del Propietário página 3

Power Wiring Connections
NOTE: Consult the product wiring diagram
located on the starter enclosure for customized
panels.
• Wire main power input and motor leads to the
appropriate terminals, tightened as indicated in
the "Specifications" on page
• Use only copper conductors rated at least 167 °F
(75 °C).
• Maintain proper clearances and verify that no
possibility of an electrical short exists between
the power conductors or enclosure.
• Ensure that wires are not under stress and all
insulation is intact.
• Verify voltage input matches label.
• Low voltage and automation system wiring
should be run in a separate conduit.
2.
L1 L2 L3 GND
200-600
VAC input
L1 L2 L3
OL
H1 H4
L1 L2 L3
CON
T1 T2 T3
T1 T3
T2
motor
3PH
INSTALLATION
Electrical Installation
surge
suppressor
43 31
44 32
AUX CONT
3