Skil AU0225D-00 Manual De Instrucciones página 13

Advancing/Retracting the Cable
To manually advance/retract the cable:
a. Disconnect the battery pack to the tool.
b. Lock the switch trigger by placing the direction of rotation selector in center lock position.
c. Hold the front handle with one hand and advance the cable with the other.
NOTE: Do not squeeze the AUTO-FEED lever when holding the front handle.
d. To retract the cable, hold the front handle with one hand and pull the cable with the other.
To advance/retract the cable using
the trigger switch (Fig . 5):
a. Attach the battery pack to the tool.
b. To feed the cable, set the direction of rotation
selector (1) to the forward position (far left).
c. Depress the AUTO-FEED lever (2) with one
hand, then pull and hold the variable-speed
trigger switch (3) with the other to advance
the cable.
d. To retract the cable, place the direction-of-
rotation selector (1) to the reverse position
(far right), depress the AUTO-FEED lever (2),
then pull and hold the switch trigger (3).
e. Once the cable has been advanced (or
retracted) to desired length, release the trigger.
Proper Hand Position (Fig . 6)
WARNING
ALWAYS use proper hand position as shown.
WARNING
ALWAYS hold the drain cleaner securely in
anticipation of a sudden movement of the drain
cleaner.
Proper hand position requires one hand on the
front handle, with the other hand on the main
handle.
To reduce the risk of
serious personal injury,
To reduce the risk of
serious personal injury,
Fig . 5
2
Fig . 6
1
3
13